Hello, I'm trying overlay a mask on the nifti output from TBSS 3,
however, the output from TBSS 3 has no qform or sform parameters.
fslview is able to display the images properly, however, when I attempt
to perform calculations between the mask and the TBSS 3 nifti output
(using either fslmaths, 3dcalc, or MATLAB), I am having difficulties
determining the orientation which provides an overlay for the two
images. Any advice would be appreciated. Tonya
--
____________________________________________________
Tonya White, M.D.
Assistant Professor
Division of Child and Adolescent Psychiatry F256/2B
University of Minnesota
Fairview University Medical Center
2450 Riverside Ave.
Minneapolis, MN 55454
tel. 612.273.9762
fax. 612.273.9779
email [log in to unmask] or [log in to unmask]
http://www.med.umn.edu/peds/psych/faculty/white.html
CONFIDENTIALITY NOTICE: The information contained in this electronic e-mail transmission and any attachments are intended only for the use of the individual or entity to whom or to which it is addressed, and may contain information that is privileged, confidential and exempt from disclosure under applicable law. If you are not the intended recipient, please delete this email.
|