Hello, I have a problem with ARC EDITOR V.5.0 (DOS version) I've only got the manual for a much later version, which makes using this version a bit difficult. I'm stuck on the following: When editing a map, for eg. using EDITFEATURE NODE. Which command do I use for zooming in (and subsequently out) to look at finely scaled problems. I'm aware that you can zoom in using for eg x2 or x0.5, but this just zooms into the centre, and not to the site of the problem. any assistance would be very gratefully received thank you David Oatway pp. Jim Staley ---------------------------------------------------------------------------- David Oatway Centre for Land Use and Water Resources Research Porter Building University of Newcastle Newcastle upon Tyne NE1 7RU United Kingdom Tel: +44 191 222 5956 Fax: +44 191 222 6563 URL: http://www.cluwrr.ncl.ac.uk ---------------------------------------------------------------------------- %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%