Dear FSL experts,
I already posted a similar question but I never received an answer.
From the moment I have installed the last version of FSL in my Leopard MAC
OSX, I have a problem with randomise. Independently from the geometry of
input files, the output is a file with the following fslhd output (see
below, in this case the input file was a BOLD 3x3x3mm). I found a solution
using fslcpgeom and using older randomise output files as reference, but I
would like to solve this problem.
Can anyone give me any advice about a solution of this general problem?
thank you!
Angela
sizeof_hdr 348
data_type FLOAT32
dim0 3
dim1 61
dim2 73
dim3 61
dim4 1
dim5 1
dim6 1
dim7 1
vox_units mm
time_units s
datatype 16
nbyper 4
bitpix 32
pixdim0 0.000000
pixdim1 1.000000
pixdim2 1.000000
pixdim3 1.000000
pixdim4 1.000000
pixdim5 0.000000
pixdim6 0.000000
pixdim7 0.000000
vox_offset 352
cal_max 0.0000
cal_min 0.0000
scl_slope 1.000000
scl_inter 0.000000
phase_dim 0
freq_dim 0
slice_dim 0
slice_name Unknown
slice_code 0
slice_start 0
slice_end 0
slice_duration 0.000000
time_offset 0.000000
intent Unknown
intent_code 0
intent_name
intent_p1 0.000000
intent_p2 0.000000
intent_p3 0.000000
qform_name Unknown
qform_code 0
qto_xyz:1 1.000000 0.000000 0.000000 0.000000
qto_xyz:2 0.000000 1.000000 0.000000 0.000000
qto_xyz:3 0.000000 0.000000 1.000000 0.000000
qto_xyz:4 0.000000 0.000000 0.000000 1.000000
qform_xorient Left-to-Right
qform_yorient Posterior-to-Anterior
qform_zorient Inferior-to-Superior
sform_name Unknown
sform_code 0
sto_xyz:1 0.000000 0.000000 0.000000 0.000000
sto_xyz:2 0.000000 0.000000 0.000000 0.000000
sto_xyz:3 0.000000 0.000000 0.000000 0.000000
sto_xyz:4 0.000000 0.000000 0.000000 0.000000
sform_xorient Unknown
sform_yorient Unknown
sform_zorient Unknown
file_type NIFTI-1+
file_code 1
descrip FSL5.0
aux_file
|