Thanks for all the suggestions. I think my issue is because I have a QuadroFX1400 video card and I don’t have proper drivers - the generic ones just won’t do it.
I have tried and failed miserably to install the proprietary drivers from NVidea, so I’m not going to worry about it. I only use chimera to make figures, and I can do that on my MAC easy enough.
If any of you have an easy to follow guide on disabling nouveau drivers I’d appreciate it - but no worries if you don’t.
Thanks again
Dave
On Sep 30, 2014, at 7:32 AM, Adam Ralph <[log in to unmask]> wrote:
>
> I take it you have the 32bit libraries installed. They are not normally installed
> by default. Then you need to make sure the app is linked with these 32bit libraries.
> I suspect that you may have linked to the 64-bit libraries.
>
>
> Adam
>
>
>
> > Hi all,
> >
> > So, I know this probably isn’t the right place, but I’m certain most of you here have battled/fixed > this issue. I just did a clean install of FC20 on an AMD dual core system. I opted for the 32 bit > version, as these workstations are used for multiple things (and I find that it’s just easier most of > the time, though 64 bit may be where I need to go eventually).
> >
> > Anyway - when running chimera - my computer constantly freezes. Obviously I’m missing something. I’m not doing anything fancy - I use Zalman monitors connected to generic video cards.
> >
> > I can run coot fine - I don’t know about ccp4i (it seems to run, but I haven’t challenged it in any > way).
> >
> > Any thoughts on where I should start here?
> >
> > Thanks
> >
> > Dave
|