Hi,
I am not sure if there has been any follow up on this, but I could not find
any. I just ran into the same issue, using some Bruker pseudo-2D data. It
nicely pops up a window to enter the values, but for some reason defaults to
the wrong number of entry boxes. And I also find that it does know the
proper number required since it gives you an error if you get it wrong.
Patrick
On Mon, 9 Feb 2009 17:37:06 +0000, Wayne Boucher <[log in to unmask]>
wrote:
>Hmm, this definitely sounds like it could be improved. Is this for
>NmrPipe or for Bruker pseudo-3D data (well, it might be a problem for
>both!)? (Just so I can see if I have some data I can try this out on.)
>(So for Azara pseduo-3D data it should do it all automatically.)
>
>Wayne
>
>On Mon, 9 Feb 2009, Mark Pfuhl wrote:
>
>> When I load a pseudo 3D spectrum a window pops up asking me for the point
>> values, fair enough. But why does this window not have the correct number of
>> entries, i.e. why do I have provide the correct number of fields? When I
>> click on OK before the correct number is present I get an error message
>> where it tells me how many points there are. Would it be possible to simple
>> read out that value right at the start and generate an input template with
>> the correct number of fields?
>> If that is not possible : would it be possible to move the '+' and '-'
>> buttons above the list? At the moment not only do I have to keep clicking a
>> lot but I also have to move the mouse after each click because the list gets
>> longer and moves the buttons.
>> thanks,
>> mark
>>
|