Dear SPM experts
I tried to set dti information using the diffusion II toolbox in spm5 and
spm8, but the following error occurred:
SPM8: dti_init_dtidata (v$Revision$) 07:32:38 - 18/09/2009
========================================================================
Failed '(Re)Set DTI information'
Attempted to access reset.b(2); index out of bounds because
numel(reset.b)=1.
In file
"/Applications/MATLAB_R2008a/work/spm8/toolbox/Diffusion/Preprocessing/dti_i
nit_dtidata.m" (???), function "dti_init_dtidata" at line 108.
The following modules did not run:
Failed: (Re)Set DTI information
What does it mean?
Thanks in advance
Best regards
Jürgen Hänggi
----------------------------------------------------------------------------
Juergen Haenggi
Ph.D. (Dr. des.)
Division Neuropsychology
Institute of Psychology
University of Zurich
Binzmuehlestrasse 14, PO Box 25
8050 Zurich, Switzerland
0041 44 635 73 97 (phone office)
0041 76 445 86 84 (phone mobile)
0041 44 635 74 09 (fax office)
BIN 4.D.04 (office room number)
j.haenggi[at]psychologie.uzh.ch (email)
http://www.psychologie.uzh.ch/neuropsy/ (website)
http://www.juergenhaenggi.ch (private website)
This e-mail (and any attachment/s) contains confidential and/or privileged
information. If you are not the intended recipient (or have received this
e-mail in error) please notify the sender immediately and destroy this
e-mail. Any unauthorised copying, disclosure or distribution of the
material in this e-mail is strictly forbidden.
----------------------------------------------------------------------------
|