Dear all,
I'm trying to scale a dataset where 100 frames in the middle (25
degrees) are quite bad so I would like to exclude them. Because the
angular range is too wide I can only do that by creating two runs. So
far, so good. The problem is that even if my input contains these five
lines:
Data line--- run 1 INCLUDE batch 1 to 550
Data line--- run 2 INCLUDE batch 651 to 720
Data line--- RUN 1 reference
Data line--- name run 1 project sls090624 crystal WHALE4 dataset sls
Data line--- name run 2 project sls090624 crystal WHALE4 dataset sls
scala ends with this error:
**** Run 2 has not been assigned to a dataset ****
Scala: ***** Error in input *****
I'm almost certain I've seen this before, but I don't remember the
cure... I would appreciate if someone can help.
Best regards,
Miguel
--
Miguel Ortiz Lombardía
Architecture et Fonction des Macromolécules Biologiques (UMR6098)
CNRS, Universités d'Aix-Marseille I & II
Case 932
163 Avenue de Luminy
13288 Marseille cedex 9
France
Tel : +33(0) 491 82 55 93
Fax: +33(0) 491 26 67 20
e-mail: [log in to unmask]
Web: http://www.pangea.org/mol/spip.php?rubrique2
|