Dear Bjorn,
you may want to have a look at the batch mode - especially if you intend
to use SPM8. I'm afraid DCM isn't yet batch-enabled, but first level
fMRI analysis should be fully supported. And - you can script the batch
mode to run for multiple subjects. For details, have a look at the SPM8
manual, there is a chapter about the batch interface.
Hope this helps,
Volkmar
Am Montag, den 27.10.2008, 13:29 +0100 schrieb bjorn:
> Dear list,
>
> I'm trying to put some steps of my fMRI analysis (and ideally all of
> them) into scripts to work more efficiently. Is it possible in SPM to
> perform a GLM followed by a DCM using command lines instead of the GUI?
> If so, what are the commands needed?
>
> Many thanks,
> Bjorn
--
Volkmar Glauche
-
Department of Neurology [log in to unmask]
Universitaetsklinikum Freiburg Phone 49(0)761-270-5331
Breisacher Str. 64 Fax 49(0)761-270-5416
79106 Freiburg http://fbi.uniklinik-freiburg.de/
|