Hi Kendall:
I haven't used CCP4Mg^2+ but if it is launched by a shell script that
dumbly sets the DISPLAY variable, then on 10.5 this is equivalent to a
suicide directive, since the new X11 (as of 10.5) sets the DISPLAY
variable using launchd. If this is the case, hack that line out of
the script or put in a conditional test for the operating system
version.
The latest X11 for 10.5.4 is worth getting too, as it has a lot of
improvements:
http://xquartz.macosforge.org/trac/wiki/X112.3.0
Bill
William G. Scott
Contact info:
http://chemistry.ucsc.edu/~wgscott/
On Jul 25, 2008, at 9:18 AM, Kendall Nettles wrote:
> CCPMG is launching X11 right before it quits. Could it relate to the
> version
> of X11? Coot was not working with the version that updates with the
> OSX, so
> I had to install the Xquartz version to get Coot to work.
>
> Kendall
>
>
> On 7/25/08 10:53 AM, "Jendrek" <[log in to unmask]> wrote:
>
>> Hi,
>>
>> I've had the same problem and discovered that in order to start
>> CCP4MG the
>> X11
>> must be closed.
>> So, just quit your X11 and then start again. It worked fine for me.
>>
>> Andrzej
>>
>> Kendall Nettles wrote:
>>> I have tried installing the newest version of CCP4MG 1.1.1, the
>>> closedirfix
>>> version, and QtMG 1.99.0. In each case, the program does not
>>> start. I did
>>> get a problem report for pyton, shown below.
>>>
>>> Mac ppc dual 2.7 GHz, OSX 10.5.4
>>> X11= XQuartz 2.3.0(xorg-server 1.4.2-apple5)
>>>
>>>
>>> Any suggestions would be greatly appreciated!
>>>
>>> Kendall
|