Its not in my gui interface either, but here is where you should be
able to find it:
(1) Can you find it under Batch --> tools --> DARTEL Tools?
(2) If you type, at the matlab prompt: which dartel2
it should report the path, if it returns "* not found" then dartel
isn't properly installed.
On Tue, Jun 3, 2008 at 12:29 PM, Jeff Browndyke <[log in to unmask]> wrote:
> For some reason DARTEL refuses to show up in the toolbox GUI even though it is in our MATLAB path. I ran the make.m file thinking that the runfiles needed to be recompiled, but this didn't make a difference. We're running MATLAB 7.6.0.324 (R2008a), if this helps pin down the issue. Is DARTEL run from the command line only?
>
> Thanks for any help or suggestions.
>
> Jeff
>
--
Best Regards, Donald McLaren
=====================
D.G. McLaren
University of Wisconsin - Madison
Neuroscience Training Program
Tel: (773) 406 2464
=====================
This e-mail contains CONFIDENTIAL INFORMATION which may contain
PROTECTED HEALTHCARE INFORMATION and may also be LEGALLY PRIVILEGED
and which is intended only for the use of the individual or entity
named above. If the reader of the e-mail is not the intended recipient
or the employee or agent responsible for delivering it to the intended
recipient, you are hereby notified that you are in possession of
confidential and privileged information. Any unauthorized use,
disclosure, copying or the taking of any action in reliance on the
contents of this information is strictly prohibited and may be
unlawful. If you have received this e-mail unintentionally, please
immediately notify the sender via telephone at (773) 406 2464 or
email.
|