i get 'command not found'
Matthew Webster wrote:
> Hi,
> If FSL is installed normally on your machine, then typing
> fslsplit
> at the command line should give you the usage text - does that happen or
> is the command not found?
>
> Matthew
>
>> ok, but how do i use fslsplit? can i use it with the gui or do i have
>> to type in the command line? in the second case, where do i type it? i
>> tried my linux shell, but it doesn't work there, neither does it in
>> matlab.
>>
>> Matthew Webster wrote:
>>> Hello,
>>> the fslsplit tool can be used to break a multivolume file
>>> into separate ones...
>>> Regards
>>> Matthew
>>>> dear all,
>>>>
>>>> i just finished an fmri simulation with possum. i simulated 10
>>>> volumes,
>>>> which i can look at with the fslview. however, i expected the
>>>> simulator to
>>>> produce 10 .nii files. instead i only have one, containing all of
>>>> the 10
>>>> volumes. when i open the file in SPM, for example, it looks like my 10
>>>> volumes are treated as one image. so my question is this: can i make 10
>>>> separate .nii files from the original one containing the 10 volumes?
>>>> thank
>>>> you. bjorn
>>>>
>>
>> --
>> Bjorn Roelstraete
>> Ghent University
>> Department of Data-analysis
>> H. Dunantlaan 1, B-9000 Gent, Belgium
>> Tel: 32-9-2646434
>> E-mail: [log in to unmask]
>>
--
Bjorn Roelstraete
Ghent University
Department of Data-analysis
H. Dunantlaan 1, B-9000 Gent, Belgium
Tel: 32-9-2646434
E-mail: [log in to unmask]
|