Dear all,
I am trying to modify an existing mask using the VOI tools.
Specifically, I open a structural scan with a 1*1*1mm resolution, then
open a 3*3*3mm mask as a VOI and remove certain parts from the mask.
However, I haven't found a way to then save the mask at its original
resoluation - it always adopts the higher resolution from the underlying
structural. Is there a way to do that in MRICron?
Best,
Thomas
--
---------------------------------------------------------
Dr. rer. nat. Thomas Wolbers
Department of Psychology
UC Santa Barbara
Santa Barbara, CA 93106-9660
U.S.A.
-
email: [log in to unmask]
www.psych.ucsb.edu/~wolbers
----------------------------------------------------------
|