Dear users,
I'm trying to use batch mode and include a regressor (specified in scans) in
order to remove some dodgy scans (1 in each of two sessions).
I've been using:
movefilt = '^rp_.*\.txt$';
mnames = {'x_trans' 'y_trans' 'z_trans' 'x_rot' 'y_rot' 'z_rot'};
in order to select the realignment parameters. However, the later doesn't
show up my design matrix, thus I'm not entirely sure I'm setting this
appropriately as a regressor. Also, I think a vector of 0's, with 1's for
the bad scans would be much more appropriate. Can anyone advise on this and
suggest the appropriate batch script command?
To add to my confusion, when I try to do this manually, setting a vector as
a regressor for each session I'm getting the error "Maximum variable size
allowed by the program is exceeded" and can't work out where I'm going wrong.
I'd be very grateful if someone could point me in the right direction.
Regards, Jaclyn.
|