It turns out that the cloned spectrum does not show the peaks since the
peaklists are de-selected after cloning (thereby making the clone to be
different in settings from the original window)
Patrick
Patrick van der Wel wrote:
> Hello,
>
> I wanted to report some funny behavior that I observed after starting a
> new project. I noticed that after importing a shift list via
> formatconverter and in that process assigning that new shift list to a
> number of spectra, those spectra don't fully reflect the new shift list.
> It shows up in the experiment list, but not in an existing window
> showing those spectra: when I select a picked peak it does not show the
> available assignments. I tested whether this is fixed when I generate a
> new window by cloning the existing one but that behaves even worse: the
> already picked peak marker(s) don't show up and I am unable to pick new
> peaks in this spectrum. During all this there are no error message on
> the command line, by the way.
>
> Note that if I save the project and restart it all behaves fine again.
>
> Patrick
>
|