Kiyotaka, Thank you very much. This is exactly what I was looking for! -Betsy On Wed, Feb 25, 2015 at 8:19 PM, Kiyotaka Nemoto <[log in to unmask]> wrote: > Dear Betsy, > > I think that's how "Reset" function works. It does reset rotation as > well as origin. > > My friend wrote a tiny Matlab script which only resets the origin. > Please try the attached script. > > Though it is very simple, I wrote how to use the script in my blog. > > http://www.nemotos.net/?p=1070 > > Hope this helps, > > Kiyotaka > > 2015-02-26 8:24 GMT+09:00 Elizabeth Bartlett > <[log in to unmask]>: > > Hello all, > > > > When I am in "Display" mode in SPM8 and click the "Reset..." button, > which I > > believe is supposed to set the origins of the images to the center of the > > volumes and set all the rotations back to zero, it not only sets the > origin > > position to the center of the image, but also changes the orientations of > > the views. Normally, when I pull up ".nii" or ".hdr/.img" files, the > views > > show up as coronal (top left), sagittal (top right), and transverse > (bottom > > right). After clicking on "Reset...", the views now show up as > transverse (top > > left), coronal (top right), and sagittal (bottom left). > > > > This becomes an issue when I then try to register my image to the > template > > image. Has anyone else had this issue? Is there a way to switch the > order of > > the imaging planes or is this something that is going wrong with the > > "Reset..." button? > > > > Thank you! > > > > -Betsy > > > > > -- > Kiyotaka Nemoto, M.D., Ph.D. > Assistant Professor > Department of Psychiatry > Division of Clinical Medicine, Faculty of Medicine > University of Tsukuba > 1-1-1Tennodai Tsukuba, Ibaraki 305-8575, Japan > E-mail: [log in to unmask] >