Hi Mark,
I'm very sorry. I did a multi-part message so I could attach my design file, but wrote the actual message in the plain text box and it must not have sent. I'm running a repeated measures ANOVA (2x2 design). After looking through the message boards, I'm pretty clear on the GLM I need to set up, but would appreciate verification that this is the right design, and would like clarification on one point. My design is an intervention study with an experimental and control group. The task is an event-related design, and I have already run the first-level analysis (see the design file previously attached). The first-level produced three lower-level copes. Thus, I believe my higher level design would look similar to the example on the FEAT user page for repeated measures ANOVA, 2x2 design. For example, with two subjects (1 control, 1 experimental) my design file would look something like:Group EV1(Time) EV2(Group EV3(Interaction)Input1(subject1-pre) 1 1 1 1Input2(subject1-post) 1 -1 1 -1Input3(subject2-pre) 1 1 -1 -1Input4(subject2-post) 1 -1 -1 1The contrasts would then be:EV1 EV2 EV3ME Time 1 0 0ME Group 0 1 0GroupxTime 0 0 1My questions are, is this the appropriate set-up for my analysis?
And, I also noticed a fourth EV on the FEAT User guide example of 2x2 ANOVA with all 1's. I wasn't sure what the purpose of the 4th EV was and whether I would need it in my analysis. If you could provide further clarification on these points, I would greatly appreciate it. Thank you very much for your time.
Hi,
I'm afraid that there was no question in this email, just an image.
Can you re-post the question?
All the best,
Mark
On 25 Jun 2014, at 22:39, Alisha Janssen <[log in to unmask]> wrote:
> <firstlevel_post.png>