Are you sure it is because of [x x]? I did steady state localization at 10Hz [10 10] and had not such problems. best, Stephan ________________________________________________________ Stephan Moratti, PhD see also: http://web.me.com/smoratti/ Universidad Complutense de Madrid Facultad de Psicología Departamento de Psicología Básica I Campus de Somosaguas 28223 Pozuelo de Alarcón (Madrid) Spain and Center for Biomedical Technology Laboratory for Cognitive and Computational Neuroscience Parque Científico y Tecnológico de la Universidad Politecnica de Madrid Campus Montegancedo 28223 Pozuelo de Alarcón (Madrid) Spain email: [log in to unmask] Tel.: +34 679219982 El 01/10/2012, a las 18:09, Jérôme Courtemanche escribió: > Hi all, > > In the MEG source inversion, the frequency of window of interest cannot > be [x x] but can be [x x+1]. If it is [x x], a window of error popped out: > > Error in job execution Error using ==> <a href="matlab: > opentoline('cfg_util.m,835,0)">cfg_util > at 835</a> Job execution failed. The full log of this > run can be found un MATLAB command window, starting with > the lines (look for the line showing the > exact #job as displayed in this error message) > _______ > Running job #1 > _______ > In the matlab window, there is no message error, only this: > Done 'M/EEG inversion results' > The following modules did not run: > Failed: M/EEG source inversion > > So how could I localize precisely 7Hz activity, for instance? > Any help welcome, > > Jerome