Dear all, Just a sorry email for mistakes from previous email. I mean 1D slices but not 1D slide! Regards, Hoa Quoting Hoa Quynh Do <[log in to unmask]>: > Dear everyone, > > I would like to extract 1H slide from 1H -13C 2D spectrum and then calculate > volume of peaks in the 1H -1D spectrum. > > Following the introduction in the below link, > https://sites.google.com/site/ccpnwiki/Home/documentation/ccpnmr-analysis/FAQs/functionality#TOC-Is-it-possible-to-extract-1D-slices-from-a-2D-spectrum-and-to-display-them- > > I was able to extract 1D slide from the 2D spectrum (the 1D spectrum > is attached > below). But the problem is that there are 2 lines which are automatically > created after setting of a new window for 1D slide (axis: x=1H , y=value, > z1=13C). And I don’t know how to remove one of the lines. > > Then, I want not only to look at the 1D slice but also to know > volumes of peaks > in the 1D spectrum. In the Peak Table window, I found values of peak > volumes but > only for peaks in the 2D spectrum. > > I am using CcpNmr Analysis 2.2.2. Could someone tell me how to get 1 line in > the 1D spectrum and how to extract the peak volumes of peaks in the > 1D spectrum? > > Thank you very much in advance! > > Best regards, > Hoa > > > ---------------------------------- > Hoa Quynh Do > Research Center Jülich GmbH > Institute of Complex Systems (ICS) > ICS-6: Structural Biochemistry > Wilhelm-Johnen-Strasse > D-52425 Jülich, Germany > Phone: 0049-2461-61-8069 > Email: [log in to unmask] > > > ---------------------------------------------------------------- > This message was sent using IMP, the Internet Messaging Program. > ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program.