Print

Print
Can anybody advise if it is possible to programmatically enable the “Test” icon of the OxPack dialogue (and if so how).  As far as I can tell it seems to magically become available once the user has pressed the estimate icon (and the estimate routine has returned non zero), however I wish to enable the icon without requiring the user to run the parameter estimation (I have written a routine to save / load parameters, so I should be able to recreate a model that can take a long time to estimate without re-estimating it every time).
 
Many Thanks
 
George Taylor
 
Senior Forecasting Analyst
Demand Forecasting
Eon Energy Solutions
Ext. 02476-183337
Int. 183337
 
 
 
 
 ___________________________ Disclaimer Notice ______________________
This message and any attachments are confidential and should only be read by
those to whom they are addressed. If you are not the intended recipient, please
contact us, delete the message from your computer and destroy any copies. Any
distribution or copying without our prior permission is prohibited.

Internet communications are not always secure and therefore E.ON
does not accept legal responsibility for this message. The recipient is
responsible for verifying its authenticity before acting on the contents. Any
views or opinions presented are solely those of the author and do not
necessarily represent those of E.ON.

Registered addresses:

E.ON UK Plc, Westwood Way, Westwood Business Park, Coventry, CV4 8LG.
Registered in England and Wales No. 2366970

E.ON Energy Solutions Limited, Westwood Way, Westwood Business Park, Coventry, CV4 8LG.
Registered in England and Wales No. 3407430


Telephone +44 (0) 2476 192000
Fax +44 (0) 2476 42 5432