Dear Harsha, there is a strange change in spm_config_results.m, which I don't really understand: [hReg xSPM SPM] = spm_results_ui('Setup',job); is changed to [hReg xSPM SPM] = spm_results_ui('Setup',xSPM); (after defining xSPM). But this syntax is not supported by spm_results_ui as xSPM is interpreted as a job structure. Going back to [hReg xSPM SPM] = spm_results_ui('Setup',job); solves the problem for me. Michael. Harsha Halahalli schrieb: > Dear SPMers, > I am facing a problem with the use of 'Results Reports' utility in > spm_jobman mode in SPM5 (with updates_1782) running on Matlab 7 for Windows XP. > On running 'Results Report' after specifying the SPM.mat file, contrast > queries etc., i get the following error message > > ......................................................................... > > SPM5: spm_results_ui (v$Rev: 816 $) 09:53:27 - 07/07/2008 > ======================================================================== > > Error running job: Reference to non-existent field 'spmmat'. > -------------------------- > Done. > > ......................................................................... > > Any suggestions / help would be appreciated. > > Best Regards, > Harsha > ----------------------- > Harsha Halahalli > Research Associate > MBIAL, Department of Psychitary > National institute of Mental Health and Neuro Sciences (NIMHANS) > Bangalore - 560029, INDIA > > > -- <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< Dr. Michael Erb Sektion f. experimentelle Kernspinresonanz des ZNS Abteilung Neuroradiologie, Universitaetsklinikum Hoppe-Seyler_Str. 3, D-72076 Tuebingen Tel.: +49(0)7071/2987753 priv. +49(0)7071/61559 Fax.: +49(0)7071/294371 e-mail: <[log in to unmask]> www: http://www.medizin.uni-tuebingen.de/nrad/sektion/ <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<