Dear all, we're just about to move to SLC using yaim. First we tried to move some WNs and face the following problem: the edg-replica-manager.conf is not written, but /opt/edg/etc/edg-replica-manager is left over with this content: [root@grid-wn5 edg-replica-manager]# ls edg-replica-manager.conf.template log4j.properties edg-replica-manager.conf.values and the values file seems not to be properly configured: [root@grid-wn5 edg-replica-manager]# cat edg-replica-manager.conf.values @EDG.LOCATION@|/opt/edg|location of edg middleware @[log in to unmask] local domain @[log in to unmask] host of the close SE @[log in to unmask] host of the close CE @INFOSERVICE@|RGMA|The info provider to use. It can be Stub, MDS or RGMA @RLS.MODE@|LrcOnly|The mode the RLS should be run in. LrcOnly or WithRli @[log in to unmask] properties file for the static file - only needed in Stub mode @[log in to unmask] host of the MDS info provider @MDS.PORT@|2135|The port of the MDS info provider @ROS.FAILURE@|true|Fail if no ROS is available @CONF.GCC@|_gcc3_2_2|The gcc suffix as used on the build box (empty for 2.95, _gcc3_2_2 for 3.2.) @IGNORE.PREFIX@|false|Whether the RM will ignore the lfn and guid prefix. @GRIDFTP.DCAU@|false|Does GridFTP use Data Channel Authentication (DCAU) Is this normal? Sorry if this might be a nasty question, this is the first time for us using yaim and we only tried to follow the documentation. Best regards, Eduard & Torsten <><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><> <> <> <> Torsten Harenberg [log in to unmask] <> <> Bergische Universitaet <> <> FB C - Physik Tel.: +49 (0)202 439-3521 <> <> Gaussstr. 20 Fax : +49 (0)202 439-2811 <> <> 42097 Wuppertal <> <> <> <><><><>< Of course it runs NetBSD http://www.netbsd.org ><><><><>