My main problem is how to turn DHCP ON (currently set to OFF) as we need this enabled for it to be allocated an IP address. I've downloaded some manuals from the Index website which unfortunately were pretty unhelpful. I even checked the FAQ page on Index which had something along the lines of... Q. How do I get DHCP turned on so the printer is allocated an IP address? A. If the printer is setup correctly this should not be a problem Thanks for that! So yes, I'd be very grateful to hear from anyone who has successfully set up their Index Braille printer for DHCP! Tim -----Original Message----- From: Discussion list for disabled students and their support staff. [mailto:[log in to unmask]] On Behalf Of Louise Lotz Sent: 09 December 2004 13:17 To: [log in to unmask] Subject: Re: Index Braille Printer I would also like to know as we have bought a second one and will be installing soon. Regards Louise -----Original Message----- From: Discussion list for disabled students and their support staff. [mailto:[log in to unmask]]On Behalf Of Quinn, Christine Sent: 09 December 2004 13:13 To: [log in to unmask] Subject: Re: Index Braille Printer Me too! -----Original Message----- From: Discussion list for disabled students and their support staff. [mailto:[log in to unmask]] On Behalf Of Tim Cunningham Sent: 09 December 2004 13:11 To: [log in to unmask] Subject: Index Braille Printer I was just wondering if anyone has any experience in setting up an Index Braille Embosser on a network. I would be very interested to hear from anyone who has. Thanks in advance -- Tim Cunningham Disabilities Support Technician Student Services Northumberland Building Northumbria University NE1 8ST Tel: 0797 497 2954 Email: [log in to unmask] -- This message has been scanned for viruses and dangerous content by the NorMAN MailScanner Service and is believed to be clean. The NorMAN MailScanner Service is operated by Information Systems and Services, University of Newcastle upon Tyne.