Muga, Unfortunately there is no way to do this directly in ABAQUS/Post (though I have wished many times that there was a way to double-check that my pressure loads were applied to the correct element faces). As an alternative, I typically create element sets of all elements that have pressure applied to them and then I can use the *COLORSET option in Post to change the default color of these elements. I then use the *DRAW command to can see if the pressure is being applied where I think it should be. This is an indirect (and imperfect) way of troubleshooting my model, but it's the best I can think of. Regards, Greg Cruse Oil States Industries, Inc. ----- Original Message ----- From: "Muga taguchi" <[log in to unmask]> To: <[log in to unmask]>; <[log in to unmask]> Sent: Thursday, February 24, 2000 9:21 AM Subject: Re: showing pressure load in abaqus/post Kaiser, Thank you very much for your help. Actually I want to view the applied pressure load just as viewing applied point load (cload) using *set, load display=on. Is there any command like that in ABAQUS/POST? Thanks again. Muga %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%