Dear Marko,
maybe you are using an older CAT12 version. This flag should be set in cat_defaults.m:
cat.extopts.gifti_dat = 1;
Best,
Christian
On Thu, 29 Sep 2022 16:05:48 +0200, Taubert, Marco, Prof.Dr.phil. <[log in to unmask]> wrote:
>Dear colleagues,
>
>I would like to analyze freesurfer curvature data in CAT12. For that, I
>ran the recon-all command in freesurfer and, later, entered the
>curvature files in the "Resample and Smooth FreeSurfer Surface Data"
>module in CAT12 to obtain the .gii files. However, when I ran the
>specified factorial model afterwards, I received the following error
>message:
>
>28-Sep-2022 23:00:38 - Failed 'Factorial design specification'
>Error using xmltree (line 47)
>[XMLTree] Cannot open ....
>
>The "Resample and Smooth FreeSurfer Surface Data" module does not create
>the .dat file that is usually built when preprocessing is done via CAT12
>entirely. Is there a way to circumvent this problem and to run the
>statistical models in CAT12?
>
>Thanks in advance for your help!
>
>Best regards,
>Marco
|