Hi
I am facing a problem with sections constructed in Move. In the attached
figure you will see two sections in a 3D model. The polygons in the straight
section are smooth and nice while in the bend section they have gaps. I
tried resampling the polygons with 100m ,it reduced the gaps but still
polygons are not smooth. Does anyone faced the same issue or know the
solution? I asked a support geologist at Move but solution is not working.
Your advice can save lot of time.
Regards
Humaad Ghani
PhD student
Institute of Earth & Environmental Science
University of Potsdam, Golm Germany
[log in to unmask]
|