Dear Vasudev,
try to minimize the number of processes (2nd entry in the GUI) or even set this value to "0" to prevent that CAT12 is running the processes in the background. There should be saved some ca*.log files that you can check to see whether there are problems or not.
Best,
Christian
On Mon, 19 Sep 2016 15:45:50 +0200, Dev vasu <[log in to unmask]> wrote:
>Dear all,
>
>I have tried in and it works, I have one general question , I have 50
>subjects (25 healthy controls and 25 controls with Bilateral vestibulopathy
>) and i am using CAT for VBM and SBM analysis, earlier i have used FSL but
>i couldn't notice any changes in grey matter on global level.
>
>
>Could you please let me know the memory requirements to perform initial
>preprocessing through SPM-CAT , when i start with batch processing , my
>computer is stuck.
>
>
>Thanks
>Vasudev
>
>On 19 September 2016 at 15:18, Kiyotaka Nemoto <[log in to unmask]> wrote:
>
>> Hi,
>>
>> SPM doesn't accept .nii.gz format.
>> Just gunzip .nii.gz files and use .nii files instead.
>>
>> Hope this helps,
>>
>> Kiyotaka
>>
>>
>> 2016-09-19 21:35 GMT+09:00 Dev vasu <[log in to unmask]>
>> :
>>
>>> Dear all,
>>>
>>> Lately, i have downloaded CAT 12 for VBM analysis , while i was following
>>> the instructions cited in CAT 12, i am facing several problems.
>>>
>>> First when i load the Batch Editor and click on Volumes, i am unable to
>>> load .nii.gz files in my directory, does CAT 12 supports 4D imaging data,
>>> please kindly let me know which format i have to use inorder to load my
>>> volume data.
>>>
>>>
>>> Thanks
>>> Vasudev
>>>
>>
>>
>>
>> --
>> Kiyotaka Nemoto, M.D., Ph.D.
>> Associate Professor
>> Department of Neuropsychiatry
>> Division of Clinical Medicine, Faculty of Medicine
>> University of Tsukuba
>> 1-1-1Tennodai Tsukuba, Ibaraki 305-8575, Japan
>> E-mail: [log in to unmask]
>>
>
|