Or, seeing that this is the CCP4BB <smile>, you could use the Xia2 pipeline from CCP4i - which will also use XDS if installed on your system.
> My recommendation would be to process with XDS. By using the autoProc procedure from Global Phasing this is very easy, even for people who are normally not able to run a program without a GUI. You will then have to run XSCALE manually, which is again trivial once XDS had run correctly.
>
> Good luck!
> Herman
Tony.
On 21 Mar 2013, at 07:41, <[log in to unmask]>
wrote:
> Dear Kyriacos,
>
>
>
>
> -----Original Message-----
> From: CCP4 bulletin board [mailto:[log in to unmask]] On Behalf Of Kyriacos Petratos
> Sent: Wednesday, March 20, 2013 6:25 PM
> To: [log in to unmask]
> Subject: [ccp4bb] Scaling with SCALA high and low resolution data sets
>
> Dear All,
>
> we have two data sets at about 0.9 and 1.9 Ang. resolution collected from a single crystal.
> Integration with iMosflm seems to be fine like the scaling within each of the data sets.
> When we try to merge and scale both of them with 'Scala' we get extremely high scale factors for the lower resolution images varying between approximately 30 and 200!
> Do we need to pay attention to some particular options for running the program(s)?
> Thank you,
>
> Kyriacos
> e-mail: [log in to unmask]
|