Hi,
Apologies for the off-topic question, but does anyone have any experience in using the Cubify 3D printer (http://www.cubify.com/) for printing protein models? Are the models robust? Is the resolution sufficient? The unit price suggests that the printer is very low-end (though the consumables are not that cheap).
sincerely
Mike Lawrence
Associate Professor and WEHI Fellow
Division of Structural Biology
Walter and Eliza Hall Institute of Medical Research
1G Royal Parade, Parkville
Victoria 3052, AUSTRALIA
Tel. 61-3-9345-2693
Fax 61-3-9345-2686
Email: [log in to unmask]
______________________________________________________________________
The information in this email is confidential and intended solely for the addressee.
You must not disclose, forward, print or use it without the permission of the sender.
______________________________________________________________________
|