Hello FSL world,
We are using the applywarp command to make an affine transform from one session
to another. Can you use 'applywarp' without using the interpolation (--interp)
flag? If you do not specific a --interp flag does it do the default, which is
trilinear correct? Or with the --interp left off, will no interpolation been
done? Is there a way to set up the command line so that you force no
interpolation?
Thanks so much!
Sandra
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
|