60% occupied Zn site perhaps ?
Q2 do you have leftover atoms from a previous dual conformation refinement ?
Try deleting the corresponding residues in a texteditor and not coot to ensure they are really gone, then rebuild the section into the new diff- map.
Jürgen
......................
Jürgen Bosch
Johns Hopkins Bloomberg School of Public Health
Department of Biochemistry & Molecular Biology
Johns Hopkins Malaria Research Institute
615 North Wolfe Street, W8708
Baltimore, MD 21205
Phone: +1-410-614-4742
Lab: +1-410-614-4894
Fax: +1-410-955-3655
http://web.mac.com/bosch_lab/
On May 26, 2011, at 6:11, Petr Kolenko <[log in to unmask]> wrote:
> Dear colleagues,
>
> I have two problems in two structure refinements using REFMAC5.
>
> 1) 1.8A resolution, zinc in the active site. Refinement using work
> reflections - ADP for Zinc was about 14. Final refinement including
> all reflections increase ADP to 20 or even higher values - followed by
> very high positive difference density in position of the zinc. I have
> tried also PHENIX, the same thing. I changed ADP manually to 14 and
> only calculated maps (no refinement) look good. May I deposit the
> structure using "manually" fixed ADP according to the best agreement
> to the observed and difference electron density? By the way, it is
> clear that this is zinc.
>
> 2) 1.9A resolution, about 600AA, all of them OK in electron density.
> But, somehow, about ten atoms give very strong positive electron
> density suggesting they are not taken into account in refinement. On
> the other hand, ADPs are reasonable and seem to be refined. All of
> these atoms are fully occupied. I tried to omit whole residues and
> build them again, but the maxima appeared again. Using of PHENIX
> resulted in no difference electron density for these atoms. I have
> also tried to take PHENIX output to REFMAC, but the maxima are there
> again. It is always one or two atoms from the same residues -
> sometimes Calpha, sometimes Cbeta, sometimes C, sometimes NH1, but
> still on the same five residues. Does anyone have any idea how to
> solve this problem?
>
> Many thanks for any response.
>
> Petr
>
>
> --
> Petr Kolenko
> [log in to unmask]
> http://kolda.webz.cz
|