Hello,
this particular error message is more likely to occur if you have write
access but don't have enough space on your hard drive to write the whole
data that were meant to be written. So you should check whether your
disk is full or you reached your quota limit.
Best regards,
Guillaume.
On 15/09/10 00:31, Watson, Christopher wrote:
> Do you have write access for wherever the data is?
> ________________________________________
> From: Nathan Hutcheson [[log in to unmask]]
> Sent: Tuesday, September 14, 2010 4:57 PM
> To: [log in to unmask]; Watson, Christopher
> Subject: Re: mat2file error
>
> I am trying to use spm8 new segment and keep getting a error message as follows:
>
> "Running 'New Segment'
> Failed 'New Segment'
> Error using ==> mat2file
> Problem writing data (3).
> In file "[log in to unmask]" (v1355), function "subfun" at line 132.
> In file "[log in to unmask]" (v1355), function "subsasgn" at line 70.
> In file "[log in to unmask]" (v1143), function "fun" at line 74.
> In file "[log in to unmask]" (v1143), function "subsasgn" at line 20.
> In file "/Users/Shared/spm8/toolbox/Seg/spm_preproc_write8.m" (v3172), function "spm_preproc_write8" at line 196.
> In file "/Users/Shared/spm8/toolbox/Seg/spm_preproc_run.m" (v3585), function "run_job" at line 112.
> In file "/Users/Shared/spm8/toolbox/Seg/spm_preproc_run.m" (v3585), function "spm_preproc_run" at line 27.
>
> The following modules did not run:
> Failed: New Segment
>
> What can I do to fix this?
>
> Thank you for the help in advance,
> Nathan
>
>
--
Guillaume Flandin, PhD
Wellcome Trust Centre for Neuroimaging
University College London
12 Queen Square
London WC1N 3BG
|