Can you attach your batch file? Or the commands you used?
Alla Yankovskaya wrote:
> Hi all,
> I entered 9 sessions into Realign&Unwarp (3D images< SPM8, default settings, the same sequence parameters). The process has stoped on Reslicing stage, sending the followed mesage:
> ailed 'Realign & Unwarp'
> Error using ==> fclose
> Invalid file identifier. Use fopen to generate a valid file identifier.
> In file "[log in to unmask]" (v2237), function "write_hdr_raw" at line 71.
> In file "[log in to unmask]" (v1143), function "create_each" at line 27.
> In file "[log in to unmask]" (v1143), function "create" at line 15.
> In file "/usr/local/spm8/spm_create_vol.m" (v1169), function "create_vol" at line 162.
> In file "/usr/local/spm8/spm_create_vol.m" (v1169), function "spm_create_vol" at line 16.
> In file "/usr/local/spm8/spm_uw_apply.m" (v1358), function "spm_uw_apply" at line 345.
> In file "/usr/local/spm8/config/spm_run_realignunwarp.m" (v2337), function "spm_run_realignunwarp" at line 106.
>
> The following modules did not run:
> Failed: Realign & Unwarp.
> I am not Matlab user.
> I would be very pleased for any help or suggestions.
> Thank you.
>
|