Hi - this means that the stats modelling (film) didn't complete - most
likely because you had RAM problems (see the large RAM q in the FSL
FAQ) or that you ran out of disk space / quota.
Cheers.
On 7 Aug 2009, at 20:53, Vishwadeep Ahluwalia wrote:
> Hi,
> I tried to run a 1st level analysis and it ran ok till the stats
> section but
> in post stats it gave the following error:(in the report.log )
> contrast_mgr stats design.con
> ** ERROR (nifti_image_read): failed to find header file for 'stats/
> corrections'
> ** ERROR: nifti_image_open(stats/corrections): bad header info
> Error: failed to open file stats/corrections
> ERROR: Could not open image stats/corrections
> Image Exception : #22 :: Failed to read volume stats/corrections
>
> obviously this file wasnt created. but i dont know why and i dont
> know how
> this file is normally used in post-stats. I ran the
> fsl_motion_outliers on
> the raw data and added the confound matrix using the "add additional
> confound' tab in FEAT. i also selected the "add motion parameters
> to the
> model" . i wonder if this procedure had something to do with the
> missing
> "correction" file. Any clues ? Thanks
> -Vish
>
---------------------------------------------------------------------------
Stephen M. Smith, Professor of Biomedical Engineering
Associate Director, Oxford University FMRIB Centre
FMRIB, JR Hospital, Headington, Oxford OX3 9DU, UK
+44 (0) 1865 222726 (fax 222717)
[log in to unmask] http://www.fmrib.ox.ac.uk/~steve
---------------------------------------------------------------------------
|