Hi Wenjing,
you are a victim of my center-of-mass approach which was intended to roughly set the
AC. However, sometimes this approach fails and you have to define the AC manually and
use the option "Set origin|use origin from header" in VBM5.1.
Best regards,
Christian
____________________________________________________________________________
Christian Gaser, Ph.D.
Assistant Professor of Computational Neuroscience
Department of Psychiatry
Friedrich-Schiller-University of Jena
Jahnstrasse 3, D-07743 Jena, Germany
Tel: ++49-3641-934752 Fax: ++49-3641-934755
e-mail: [log in to unmask]
http://dbm.neuro.uni-jena.de
On Fri, 31 Oct 2008 22:26:38 +0800, Wenjing Li <[log in to unmask]> wrote:
>Dear SPMers,
>
> I encountered some problems during my use of vbm toolbox.
> I have reoriented each image and put the origin close to AC before
>using vbm toolbox, but when I used the vbm5 toolbox in SPM5 on these images
>, I got bad results(see attached figure).
> I have run the unified segmentation in SPM5, the results were fine. I
>don't know how I should solve this problem.
>
> Thank you very much!
>
>Wenjing Li
>
|