> I was unable to assign any peaks in the third (and final) slice/plane of
> the pseudo-3D.
Fixed.
> Specifically the condition type and units for the values. Perhaps it
> would make sense to pop up that dialog box when a pseudo-3D is loaded
> into the program?
We'll either do this or have an extra pulldown menu at load time.
Additionally there have been some other changes to Analysis for pseudo 3Ds
recently which people may like to know about:
Copying of peak lists from 2D to pseudo 3Ds now works - you can either
select only one plane or all planes.
When you manually pick a peak (<Ctrl> & Left Click) peaks are now picked
in all visible planes - previously this defaulted to the centre.
Also, while I'm mentioning such things I have combined the 'Clone' and
'Reproduce' buttons into one 'Copy' button in the peak lists editor - The
clone was causing too many issues. Whether to clone or reproduce is
decided internally; cloning is quicker but is only done if peak lists
share the same spectrum where the dimensionality and point to ppm mappings
can be guaranteed.
T.
-------------------------------------------------------------------------------
Dr Tim Stevens Email: [log in to unmask]
Department of Biochemistry [log in to unmask]
University of Cambridge Phone: +44 1223 766018 (office)
80 Tennis Court Road +44 7816 338275 (mobile)
Old Addenbrooke's Site +44 1223 364613 (home)
Cambridge CB2 1GA WWWeb: http://www.bio.cam.ac.uk/~tjs23
United Kingdom http://www.pantonia.co.uk
-------------------------------------------------------------------------------
------ +NH3CH(CH(CH3)OH)C(O)NHCH(CH(CH3)CH2CH3)C(O)NHCH(CH2CH2SCH3)CO2- -------
-------------------------------------------------------------------------------
|