Hi Li,
setpaths.sh (and variants for other shells) are generated during the cctbx build process (with ccp4-6.0.2, this might happen only if you're installing phaser).
If you're doing a source install from both ccp4-6.0.2.tar.gz and phaser-1.3.3-cctbx-src.tar.gz, and have extracted both of the tarballs, then most likely something has gone wrong during the configure/build process (if you're installing differently, then I might be completely off-base here). The first thing I'd check would be the version of python that's being used by libtbx.scons (with older versions of cctbx I had some problems with using python2.5 that were resolved by using python2.4 instead, although I believe these have been resolved).
Good luck,
Pete
-----Original Message-----
From: CCP4 bulletin board on behalf of Li Sheng
Sent: Thu 12/27/2007 7:58 AM
To: [log in to unmask]
Subject: [ccp4bb] setpaths.sh
Dear All,
I installed ccp4 6.0.2 on my fedora8 platform. It
seems I need one extra file named "setpaths.sh", which I can not
find in
$CCP4/lib/cctbx/cctbx_build/?&?
${CCP4}/src/phaser/phaser-${phaser_version}/build/${phaser_mtype}/
Where can I get such a file?
Thanks in advance.
Sincerely,
Li
12/27/2007
|