This error
>spm_slice_vol.c not compiled - see Makefile
>--------------------------
means just that. spm_slice_vol.c has not been compiled or has not been
compiled correctly. The Makefile contains the commands to compile the
.mex files needed for SPM to run, so it is possible that there was an error
during your SPM installation, or you forgot to compile the files in the
first place. The Makefile is located at spm5/src, and if you open it in a
text editor, you can find instructions on how to compile the .mex files for
all supported platforms. You could also look at
http://en.wikibooks.org/wiki/SPM/Installation_on_Mac_OS_(Intel) for
information on installing SPM5 on an Intel Mac, for example. You can find
instructions for the other platforms by searching wikibooks.org.
I would check to make sure that you ran all of the necessary installation
steps before attempting to use SPM. I hope this helps.
Good luck!
Liberty Hamilton
Laboratory of NeuroImaging, UCLA
|