It appears that CCP4i is accessing an older version of Phaser, which
will generate this error. Phaser 1.3.3 is current for CCP4 6.0.2. I had
a similar problem when I had a stand-alone install of Phaser and later
upgraded to a CCP4 package that contained its own version of Phaser. I
think you have to eliminate the path conflict with your different
versions of Phaser.
Cheers,
___________________________________________
Roger S. Rowlett
Professor
Department of Chemistry
Colgate University
13 Oak Drive
Hamilton, NY 13346
tel: (315)-228-7245
ofc: (315)-228-7395
fax: (315)-228-7935
email: [log in to unmask]
-----Original Message-----
From: CCP4 bulletin board [mailto:[log in to unmask]] On Behalf Of Ed
Wright
Sent: Saturday, June 09, 2007 7:17 PM
To: [log in to unmask]
Subject: [ccp4bb] problems with phaser for MR
Dear All,
I can't seem to read my mtz files with 'PHASER for MR' in version ccp4i
6.0.2 running on either a linux or irix system. I can read the mtz files
with virtually every other CCP4 subroutine. Any ideas/suggestions?
The error I get in the log file is "
************************************************************************
****
*********
*** Phaser Module: READ MR DATA FROM MTZ FILE
1.3.1 ***
************************************************************************
****
*********
----------------------------------------------------
FATAL RUNTIME ERROR: Cannot open MTZ file:
"/home/elias/mergedata/p4/ccp4/sort_p4.mtz"
----------------------------------------------------
--------------------
EXIT STATUS: FAILURE
|