Hello Arti,
To be able to input external phases as HL you have to set the "User
level" in the "Preferences" to "Advanced" or "Expert". I think that also
changes the options you have in the "phase improvement panel".
Sabine
Sabine Schneider
School of Pharmacy and Centre for Biomolecular Sciences
Clifton Boulevard
University of Nottingham
NG7 2RD
Phone: +44 115 8468009
Fax: +44 115 8468002
> -----Original Message-----
> From: CCP4 bulletin board [mailto:[log in to unmask]] On Behalf Of
> [log in to unmask]
> Sent: 26 March 2007 19:09
> To: [log in to unmask]
> Subject: [ccp4bb] SHARP question
>
> Hi all,
> I am a first time SHARP user. I have it installed on SUse 10.0 OS and
> configured to ccp4-6.0.2. I do not see the option for inputting known
> phase information from my .mtz file on the "Global" page, even if the
mtz
> file has the Hendrickson-Lattman coefficients. Also, in the "Phase
> improvement panel", for Density Modification, only "solvent fraction"
and
> "including available partial Model" options are active. I was assuming
> that the defaults would be used. So even though "starting DM run/" is
set
> to "no", DM runs anyway, outputting Fdm, Phidm, HL..dm etc.
> Is it mandatory that the program be configured to ccp4 version 5?
> Is this an installation problem?
> Appreciate any help.
> Thank.
> Arti Pandey
> Chemistry & Biochemistry
> Montana State University
> Bozeman MT 59715
This message has been checked for viruses but the contents of an attachment
may still contain software viruses, which could damage your computer system:
you are advised to perform your own checks. Email communications with the
University of Nottingham may be monitored as permitted by UK legislation.
|