Hi there,
I've had a couple of problems with filtering when using the Browse
Resonances Pop-up which I would probably class as bugs.
(1) I currently don't have any full assignments for any of my
resonances, but almost all of them have been assigned an amino acid
type. But when I then try filtering the list by CcpCode, I don't see
anything at all (see figures below). It would seem most logical to me
that the CcpCode filtering should be independent of full assignments to
a particular residues in the sequence and should just go by amino acid
type instead.
(2) To overcome problem (1) I was using the normal filtering pop-up and
simply entering my amino acid code. However, each time I did something
like 'Deassign' or 'Assign Atom Type' etc. the list went back to the
full list, and I had to press 'Filter' again to see only the amino acid
type I wanted. Like (1) this isn't a direct problem as such, but quite a
hassle. Would it not be possible to leave the list unfiltered until
pressing 'Reset' in the Filter pop-up?
Thanks,
Vicky
--
****************************************************
Dr. Victoria A. Higman
Leibniz-Institut fuer Molekulare Pharmakologie (FMP)
Robert-Roessle-Str. 10
13125 Berlin
Germany
Phone: +49-30-94793 223
E-mail: [log in to unmask]
****************************************************
|