Hi,
I think the answer is that you should install/configure also a site-BDII
(even if the functions for a gliteCE already contain the ones specified
for BDII_site) .
See
http://grid-deployment.web.cern.ch/grid-deployment/documentation/LCG2-Manual-Install/LCG2-Manual-Install.html#SECTION000132000000000000000
So you shoud check if bdii is running (service bdii status).
Cristina
Louis Poncet wrote:
> Hi,
> It is totally normal the gliteCE only use the BDII.
>
> Lp
> --
> Laird Louis Poncet
> Where: Bat28-R-003 CERN
> CH-1211 Geneve 23
> Mail : [log in to unmask]
> Phone: +41(0)227.674.231
> LAL / IN2P3 / CNRS / CERN
>
>
>
> On Oct 3, 2006, at 10:20 AM, [log in to unmask] wrote:
>
>> Dear all,
>>
>> I installed a glite-CE with the yaim tool and run the commands below to
>> do it
>> ../scripts/install_node site-info.def glite-CE glite-WN
>> glite-torque-server-config glite-torque-client-config
>> ../scripts/configure_node site-info.def gliteCE WN_torque TORQUE_server
>> However, when I check if the gliteCE is running a globus-mds I get :
>> ----------
>> [root@ce1 root]# /etc/init.d/globus-mds status
>> Missing MDS configuration
>> ----------
>>
>> Am I suppused to configure the globus-mds service manually after the
>> yaim install_node/configre_node commands ?
>> Is not there a globus-mds service running on a glite-CE node ?
>> How does the glite-BDII do to retreive the information about a gliteCE?
>>
>> Thanks and regards
>>
>> Ahmed Beriache
>
>
--
---
Cristina Aiftimiei - EGEE Project
Ist. Naz. di Fisica Nucleare - Padova
Address: via F. Marzolo, 8 - 35131 Padova - ITALY
Phone: +39.049.8277005
Mobile: +39.3460230488
|