Hi again
I've a question about the Rate Analysis part of analysis. I have loaded in
my T2 spectra etc, calculated errors for each and put them in the
condition point errors. When I select Group Peaks I get a set of results,
however if I select Recalculate All Rates, without changing anything, the
TC error changes. When pressed again it changes to something different
again. I also found that there usually is an error which is miles out from
the rest (i.e. say if most were around 10 then the odd one was maybe 6000,
or something ridiculously small). Recalculate and the no. changes again.
Have I fed something in wrong or is something dodgy going on?
I don't understand why the error changes each time.
Thanks
Eve
--
|