peak intensity type is always set to volume. i do have an old peak list but when
i use the recalculate intensities option, the intensities change by only a very
small amount (0.02 or so). ?
phil
Quoting Tim Stevens <[log in to unmask]>:
> The intensity types may be mixed. One set of constraints may have
> been created using the volumes but the other set with heights. In this
> case you would expect a fairly constant ratio between the intensities for
> the same peak, given that our rudimentary peak picker/integrator is based
> upon a simple parabolic fit.
>
> If this is not the issue, then the only other thing that springs to mind
> is that the way that volumes are calculated for peaks has changed since
> the early versions of Analysis. So, if you have an old peak list you may
> want to recalculate intensities (from the peak list editor).
>
> Tim
>
>
-------------------------------------------------------------------------------
> Dr Tim Stevens Email: [log in to unmask]
> Department of Biochemistry [log in to unmask]
> University of Cambridge Phone: +44 1223 766022 (office)
> 80 Tennis Court Road +44 7816 338275 (mobile)
> Old Addenbrooke's Site +44 1223 364613 (home)
> Cambridge CB2 1GA WWWeb: http://www.bio.cam.ac.uk/~tjs23
> United Kingdom http://www.pantonia.co.uk
>
-------------------------------------------------------------------------------
> ------ +NH3CH(CH(CH3)OH)C(O)NHCH(CH(CH3)CH2CH3)C(O)NHCH(CH2CH2SCH3)CO2-
> -------
>
-------------------------------------------------------------------------------
>
|