Dear SPM group:
I recently met a probelm about the "print" function of SPM99.
Previously I used matlab53, Window NT4.0 and SPM99 updated and ghostview
5.1; with htis combination, the "print" funciton of SPM99 work fine to save
to ps file.
Now, I upgraded ghostview 5.5, and found the ps file save by "print"
function is strange, as the attached ps file.
I tried to restore to ghostview 5.1, the same.
The condition is the same on my another PC runing Win2000, Matlab53, SPM99
and ghostview5.5
Has anybody had similar experience or advice for this problem?
P.S. I installed sigmaplot2000 demo in the mean while, but I have removed it
now.
Sincerely
Ming-Ting
================================
Wu, Ming-Ting, M.D. Depart. of Radiology
Kaohsiung Veterans General Hospital, 813
Kaohsiung , Taiwan
Tel: 886-7-3422121 ext 6205, 6235
Fax: 886-7-3468301
Mobil: 0920-040-712
----- Original Message -----
寄件者: Wu, Ming-Ting <[log in to unmask]>
收件者: NTU_莊凱翔 Kai-Hsiang <[log in to unmask]>
傳送日期: 2000年12月5日 PM 06:20
主旨: ps problem.
> Dear Kai-Hsiang:
> After install the new ghosttool and sigmaplot6.0, I encounter a strange
> problem in SPM99.
> Usually I push the bottom of "print" in the SPM99 window, the display will
> be saved as ps file. But now when I open the ps file with ghostview, I
found
> the ps file was not completely saved. please see the attached file, this
> should be the T1.img template of SPM.
> I have tried to remove the ghostview and re-install the matlab and
> ghostview, OLD version, but the same.
> Have any idea?
>
> Sincerely
>
>
> Ming-Ting
>
> ================================
> Wu, Ming-Ting, M.D. Depart. of Radiology
> Kaohsiung Veterans General Hospital, 813
> Kaohsiung , Taiwan
> Tel: 886-7-3422121 ext 6205, 6235
> Fax: 886-7-3468301
> Mobil: 0920-040-712
>
|