Hello!
I'm solving an electric field problem with ANSYS. I use a command file
that set the loads, set the time, and solves the problem, doing that 25
times with different loads.
When 5 steps are solved, ANSYS stops its execution, and says that
there's not enough memory. My question is the following:
The results file (rth in my case) exists in my disk. How can I continue
solving the rest of the problem? Its possible to apply some load cases,
and continue with more other day, in other ANSYS session?
Thanks a lot in advance.
--
Ing. Félix Torán Martí.
Aplicaciones Tecnológicas, S.A.
e-mail: [log in to unmask]
tel. +34 654082088
WWW:
----
FREEXTRON (Guia de lo GRATIS de Internet):
http://freextron.informaticos.org
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
|